I configured VIEW to start TCC21 instead of CMD (tools\CommandPrompt). When I use that tool, I get a message box saying that my TCC21 trial has expired.
And if I choose "Register" and enter my key, it says the key does not correspond to v21. This hasn't otherwise affected v21. If (not that it was necessary) I enter the same key in v21's OPTION\Register dialog, I get a successful registration.
I have only one v21 installation; it has both TCC and TCMD.
V ... Preferences/options ... Editor/CMD ... Use the following command processor instead of CMD ... if I give g:\tc21\tcc.exe (option "/q") and use the tool, I get the expired dialog. I can't rely on COMSPEC not changing to CMD because TCC itself changes COMSPEC to CMD whenever it gets WM_SETTINGSCHANGE, "Environment".
I must apologize again. It was my mistake, in fact, two mistakes. 1. I forgot that I had TCC 21.0.17.0 installed, and 2. when navigating in V to find TCC.EXE, I clicked on the TCC21 folder instead of the TC21 folder
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.